Parts Hub

Frigidaire & Electrolux Dryer Thermal Fuse Parts — Models & Compatibility

1 parts available
Covers 20+ models
Ships 2–5 days
Series
FAQE, BAQE, EFME, EFMC Series
Models covered
20+
Price range
$19.99
134711401 134711401 Outlet Thermal Fuse Compatible with Frigidaire Electrolux Kenmore Gibson, Replaces AP5645246 PS4704883 134711400 2688797

Your Frigidaire or Electrolux dryer powers on but won't heat, or worse — it won't start at all. The outlet thermal fuse is often the culprit, and it's designed to fail when your dryer overheats from restricted airflow or a heating element issue. This hub covers the 134711401 thermal fuse that fits over 20 Frigidaire, Electrolux, Kenmore, and Gibson dryer models, including the FAQE and EFME series.

Is This the Right Part for Your Model?

Check your dryer's model number — it's usually on a sticker inside the door frame or on the back panel. Match it against the compatibility list below. This fuse replaces part numbers AP5645246, PS4704883, 134711400, and 2688797, so if you've seen those numbers referenced in your manual or by a repair tech, you're in the right place.

About This Replacement Part

The 134711401 outlet thermal fuse is a one-time safety device that cuts power to the heating circuit when temperatures exceed safe limits. This thermal fuse fails when the dryer overheats due to restricted airflow or a malfunctioning heating element. Once it blows, your dryer either won't start or will run without heat. You can't reset it — you have to replace it. Common scenarios: lint buildup in the vent restricts airflow, the blower wheel stops spinning, or the heating element shorts out. All three push internal temps past the fuse's threshold, and it sacrifices itself to prevent a fire. If you're replacing this fuse, inspect your vent system and heating element at the same time, or you'll be swapping fuses again in a few months.

Compatible Frigidaire & Electrolux Models

This thermal fuse fits the following dryer models. If your model isn't listed, double-check the part number on your existing fuse or contact us for verification.

Frigidaire Models

  • FAQE7001LW0, FAQE7001LW1
  • BAQE7073KW0
  • BAQE7077KB0, BAQE7077KW0
  • BAQG7073KW0
  • BKQE7017KT0

Electrolux Models

  • EFME417SIW0, EFME517SIW0, EFME617SIW0
  • EFMC617SIW0, EFMC517SIW0
  • EFDC317TIW0

Common Symptoms When This Fuse Fails

Two telltale signs point to a blown outlet thermal fuse:

  • Won't Start: You press the start button, the control panel lights up, but nothing happens. The drum doesn't turn, no heat, no action.
  • Not Heating: The drum spins, the timer counts down, but your clothes come out damp and cold after a full cycle.

Both symptoms mean the thermal fuse opened its circuit. Test it with a multimeter set to continuity — a good fuse reads zero ohms, a blown one reads infinite resistance.

Why This Fuse Keeps Blowing

If you've replaced this fuse before and it failed again, you've got an underlying issue. The fuse itself isn't defective — it's doing its job by shutting down an overheating dryer. Check these three things before ordering a replacement:

  • Vent System: Pull the vent hose off the back of the dryer. Is it packed with lint? Run your hand through it. If airflow is restricted, the dryer can't exhaust heat properly.
  • Blower Wheel: A broken or clogged blower wheel stops air circulation. Listen for unusual rattling or weak airflow at the vent outlet.
  • Heating Element: A shorted or grounded element cycles heat too aggressively. Inspect it for breaks or spots where the coil touches the housing.

Fix the root cause, then replace the fuse. Otherwise you're treating the symptom, not the disease.

Installation Tips

Unplug the dryer first — no exceptions. The thermal fuse is usually mounted on the blower housing or near the heating element. You'll need a 1/4" nut driver or socket to remove the mounting screws. The fuse has two wire terminals — take a photo before disconnecting them so you remember which wire goes where. Push the new terminals on firmly until they click. If they feel loose, use needle-nose pliers to tighten the connectors slightly before attaching them to the fuse.

Part Numbers Cross-Reference

This thermal fuse replaces the following OEM and aftermarket part numbers:

  • 134711401 (current Frigidaire number)
  • AP5645246
  • PS4704883
  • 134711400 (older version)
  • 2688797

If your repair manual or parts diagram lists any of these numbers, the 134711401 is the correct replacement.

Order Your Replacement Fuse

The 134711401 outlet thermal fuse is in stock at $19.99. It ships same-day if you order before 3 PM EST. Questions about compatibility? Our parts team has the full model cross-reference and can verify fit in under two minutes.

Select your model
FAQE Series
FAQE7001LW0
1 parts available
Browse Parts
FAQE Series
FAQE7001LW1
1 parts available
Browse Parts
BAQE Series
BAQE7073KW0
1 parts available
Browse Parts
BAQE Series
BAQE7077KB0
1 parts available
Browse Parts
BAQE Series
BAQE7077KW0
1 parts available
Browse Parts
BAQG Series
BAQG7073KW0
1 parts available
Browse Parts
BKQE Series
BKQE7017KT0
1 parts available
Browse Parts
EFME Series
EFME417SIW0
1 parts available
Browse Parts
EFME Series
EFME517SIW0
1 parts available
Browse Parts
EFME Series
EFME617SIW0
1 parts available
Browse Parts
EFMC Series
EFMC617SIW0
1 parts available
Browse Parts
EFMC Series
EFMC517SIW0
1 parts available
Browse Parts
EFDC Series
EFDC317TIW0
1 parts available
Browse Parts
Most-replaced parts for this series
134711401
134711401 Outlet Thermal Fuse Compatible with Frigidaire Electrolux Kenmore Gibson, Replaces AP5645246 PS4704883 134711400 2688797
$14.99
Add to Cart

Can't find your model?

Enter your model number and we'll confirm the right part.

Shop 134711401 →