GE Washer Door Lock Assembly Parts — Models & Compatibility

Your GE front-load washer won't start, and you hear clicking sounds from the door area. That's the door lock assembly failing — one of the most common issues in GE's GFWN and GFW series washers. This hub covers the WH10X20821 door lock assembly replacement, compatible with over 20 GE and Hotpoint washer models.

Is This the Right Part for Your Model?

Before ordering, you'll need to verify your exact model number. On GE front-load washers, the model tag is typically located inside the door opening along the front frame, or behind the detergent dispenser drawer. Look for model numbers starting with GFWN, GFW, or GFWH — this part fits the most popular GE washer series from recent years.

About This Replacement Part

The WH10X20821 door lock assembly (also sold as AP5958532, PS11699522, or 4120986) is the complete locking mechanism that secures your washer door during operation. When this component fails, your washer typically refuses to start or shows error codes related to door locking. The assembly includes the lock motor, strike mechanism, and wiring harness — everything needed for a complete repair. This genuine GE replacement part works with both standard and steam-cycle models across the GFW400, GFW430, GFW450, GFWN1100, GFWN1300, and GFWN1600 series. At $123.99, you're getting the factory-spec part that'll restore your washer to full operation.

Compatible Model Series

This door lock assembly fits across multiple GE washer product lines. The GFWN series represents GE's energy-efficient front-loaders, while the GFW series includes both basic and steam-enhanced models. If your model number starts with any of these prefixes, you're likely looking at the right part.

Common Signs You Need This Part

Door lock failures show up in predictable ways. The washer won't start even though the door appears closed. You hear rapid clicking from the door area when you press start. The control panel displays door-related error codes. Or the door won't unlock after the cycle completes, trapping your laundry inside. These symptoms all point to a failed door lock assembly that needs replacement.

Installation Overview

Replacing the door lock assembly requires accessing the front panel of your washer. You'll need to remove the door boot seal's front lip to reach the lock mounting screws. Most techs complete this repair in 30-45 minutes with basic tools. The new assembly includes the wiring connector, so you're just unplugging the old unit and plugging in the new one — no wire splicing required.